Sun Microsystems SPARCcenter 2000 Service Manual page 213

Figure 10-3 SuperSPARC Modules A and B
10.3.1 Removal
1. Unlock the four standoffs that secure the module to the system board.
Pull up the tip of a standoff to unlock it. See Figure 10-2.
2. Hold the SuperSPARC module by the edges near the connector and
carefully lift the module off the connector.
Do not "rock" the module off of the connector. Ensure vertical movement of
the module during insertion or removal process.
Caution – Risk of equipment damage: the connector housing may break if the
!
module is tilted too far.
3. Place the module in an antistatic bag.
10.3.2 Replacement
1. Unlock the four standoffs for the slot if they are not already unlocked.
Pull up the tip of a standoff to unlock it. See Figure 10-2.
2. Remove the SuperSPARC module from the protective packaging and
inspect the connector for bent pins.
3. Place the SuperSPARC module on the four standoffs and align the
module connector with the system board socket.
System Boards and Component Replacement
Super Super
SPARC
SPARC
SPAR SPAR
module
module
C C
B
A
Mod- Mod-
10
10-5