Sun Microsystems SPARCcenter 2000 Service Manual page 216

10
10-8
2. If the card has a plastic card retainer, remove it.
Spread the ends of the retainer apart to remove it from the card. The retainer
is not needed for this installation. See Figure 10-6.
Figure 10-6 SBus Card Retainer
3. If the card has an adapter bracket, remove it.
Using a #0 Phillips screwdriver, remove the two screws securing the adapter
to the card rear panel. The adapter bracket and the screws are not needed
for this installation. See Figure 10-7.
Remove adapter
Figure 10-7 SBus Card Rear Panel with Adapter
4. For DSBE/S card only: remove the two outer retaining screws, but do NOT
remove the middle screw or the springfinger.
You will need a #1 Phillips screwdriver and a 3/16 nut driver or socket
wrench. See Figure 10-8.
SPARCcenter 2000/2000E Service Manual—June 1996
Remove screws