8. Remove the cover from the tray and set aside.
To add or replace disk drives in the tray, see Section 9.7, "5 1/4-Inch Disk
Drive," on page 9-26.
7.13.1 Fan Tray Assembly
Perform these tasks in order to replace the fan tray assembly.
Safety and Tools Requirements
Powering Off the System
Vented Front Panels
Rear Screen Panel
Differential SCSI Disk Tray
It is not necessary to remove the disk drives from the differential SCSI disk
tray. See Figure 7-46 and proceed as follows:
1. Remove the DC harness fan connector (P9) from the fan DC receptacle.
Squeeze the locking tabs on the connector, and gently pull the connector.
2. Remove the four hex-head screws that hold the fan tray assembly in place.
Lift the fan tray assembly out.
Major Subassemblies
7
page 5-1
page 6-1
page 7-3
page 7-4
page 7-47
7-49