Figure 9-29 Right Drive Bay Device Select Switch - Sun Microsystems SPARCcenter 2000 Service Manual

9
9-24
b. Attach the fan subassembly bracket to the right side of the autoloader.
The fan will be at the rear of the unit when the bracket is properly
aligned.
Note – The fan subassembly bracket can be attached to the right side of the
autoloader only. Holes in the bracket will not line up properly on the left side.
5. Locate the SCSI address cable for the auto-loader.
The address cable is plugged into the device select switch for the bay where
the autoloader is installed. Figure 9-29 shows the device select switch on the
left side of a right drive bay. Drives installed in left drive bays have device
select switches on the right side of the drive.
Device select switch
0

Figure 9-29 Right Drive Bay Device Select Switch

6. Position the auto-loader in front of the drive bay. Plug the address cable
into the SCSI ID connector at the rear of the auto-loader (Figure 9-30).
Position the address cable so that the black wire is located at the lower right
corner of the SCSI ID connector.
7. Plug the power harness cable from the drive bay into the power connector
(P1) attached to the fan assembly bracket on the drive.
8. Plug the SCSI data cable from the drive bay into the SCSI connector on
the auto-loader.
9. Tuck the cables in behind the autoloader and slide the drive into the drive
bay. See Figure 9-31.
SPARCcenter 2000/2000E Service Manual—June 1996
Cassette Warning Open/Close
Compress Write Protect Step