Figure 9-23 Connector Locations On The 4 Mm Tape Auto-Loader - Sun Microsystems SPARCcenter 2000 Service Manual

Power connector
SCSI connector
SCSI ID connector

Figure 9-23 Connector Locations on the 4 mm Tape Auto-Loader

Note – The auto-loader power connector has a fan power cable plugged in.
This hardwired fan power cable, which extends from the fan, connects the
auto-loader and the SCSI tray.
•
Power cable — Unplug both ends of the fan power cable (Figure 9-20).
Grasp the cable connector on both sides and firmly, but gently, pull the cable
away from the autoloader power connector and SCSI tray cable connector.
•
SCSI ID cable — Grasp the cable connector on both sides and firmly, but
gently, pull the cable away from the SCSI ID connector.
•
The SCSI data cable is easily damaged by excessive force. To remove this
cable safely, grasp the strain relief tab and pull gently. See Figure 9-19.
Storage Devices
9
9-19