Sun Microsystems SPARCcenter 2000 Service Manual page 123

Figure 7-17 Removing the Top Power Supply
4. Remove the springfingers.
Remove three screws securing each of the two sets of springfingers to the
face of the supply. See Figure 7-17. Set these aside for installation on the new
power supply.
Replace the Power Supply
1. Install the springfingers from the old supply onto the new supply.
2. Install the new supply using Section 7.3.2.1, "Top Power Supply" in
reverse order.
Major Subassemblies
7
Power supply
Springfingers (2 each)
7-17