Installing A New Tape Drive; Figure 6-11 Removing Or Attaching The Baseplate To The Tape Drive - Sun Microsystems 817-4054-15 Servise Manual

FIGURE 6-11
8. Attach the baseplate to the new tape drive. Use the four countersunk screws
shipped with the drive (
9. Install the new drive. Insert it into the system until the metal latch on the left side
engages.
6.3.2

Installing a New Tape Drive

1. Take the system to Standby mode.
See Section 4.2, "Taking the System to Standby Mode" on page
2. Open the right front door of the system.
3. Attach a wrist strap. Place a grounded ESD mat close to the system.
See Section 2.8, "Antistatic Precautions" on page
4. Pull the tape drive filler panel forward to remove it.
5. Remove the two countersunk screws that secure the tape drive filler panel to the
baseplate (
6-12 Sun Fire E2900 System Service Manual • May 2006
Removing or Attaching the Baseplate to the Tape Drive
FIGURE 6-11
). Remove the tape drive filler panel.
FIGURE 6-12
Baseplate
).
2-6.
4-2.