Sun Microsystems SPARCcenter 2000 Service Manual page 60

2
2-16
• To limit the probing to SCSI devices that are attached to a specific SBus
card on a specific board, substitute for the variables A and B in the
command below, where A is the board number (0-9) and B is the SBus slot
number (0-3):
probe-scsi-all /io-unit@f,eA200000/sbi@0,0/dma@B,81000 <return>
4. Verify that the drive you have installed is listed.
After entering one of the commands shown above, you should see a list of
drives similar to the following:
Target 0
Unit 0 Disk <drive brand name>
Target 3
Unit 0 Disk <drive brand name>
Target 4
Unit 0 Tape <drive brand name>
Target 6
Unit 0 Removable Read Only device
The "Target #" lines will tell you the SCSI addresses of the devices you have
connected to your system.
If you see the SCSI address listed for the drive you just installed, then the
installation was successful. If you do not see the SCSI address for the new
drive, verify that the cables are installed correctly.
5. Enter the following command to reboot your system:
reset <return>
Your screen will go blank for several seconds after you enter this command.
Then the system will reboot.
SPARCcenter 2000/2000E Service Manual—June 1996