Figure 9-37 Jumper Settings Detail - Sun Microsystems SPARCcenter 2000 Service Manual

9
Power connector
9.7.3 Replacing the Disk Drive
9-30

Figure 9-37 Jumper Settings Detail

To install a disk drive in the tray:
1. Place the disk drive carefully on a flat surface with the electronics facing
down.
2. Align the holes at the bottom of the disk drive with the holes in the
mounting bracket.
3. Slide the plastic strap under the disk drive.
Wrap it around the slot provided. This slot is located about two-thirds of the
way towards the front of the disk drive.
4. Drape the ends of the plastic strap over each other until the holes in the
strap are aligned.
5. Press the ends of the plastic strap together so that the adhesive on the
strap keeps the holes aligned.
6. Align holes in the strap with the holes at the bottom of the drive and the
holes in the mounting bracket that are closest to the rear of the bracket.
7. Use four 6-32 screws to secure the drive and the plastic strap to the
mounting bracket. See Figure 9-38.
8. Use the plastic strap to slide the disk drive into the appropriate location
in the differential SCSI disk tray until the front of the mounting bracket
rests flush against the two alignment tabs. See Figure 9-39.
SPARCcenter 2000/2000E Service Manual—June 1996
Wait Spin Enabled connector
Sweep Cycle Enabled connector
SCSI bus parity disable connector