Figure 9-18 Drive Bay Mounting Screws - Sun Microsystems SPARCcenter 2000 Service Manual

9
9-14
2. Remove two screws securing the mounting bracket/drive to the cabinet.
See Figure 9-22.
3. Slide the drive out of the cabinet until the cables are exposed.

Figure 9-18 Drive Bay Mounting Screws

4. Unplug the power, SCSI ID, and SCSI data cables from the drive rear.
•
For the power and SCSI ID cables, grasp each cable connector on both sides
and firmly, but gently, pull the cable away from the connector at the rear of
the tape drive.
•
The SCSI data cable is easily damaged by excessive force. To remove this
cable safely, grasp the strain relief tab and pull gently. See Figure 9-19.
SPARCcenter 2000/2000E Service Manual—June 1996
Mounting Screws
Mounting screws