Sun Microsystems SPARCcenter 2000 Service Manual page 108

7
7-2
2. Tilt the top of the shield outward and lift the shield free of the chassis.
Set the shield aside.
Note – Use care to ensure you do not damage the springfingers.
Figure 7-1 EMI Shield Removal and Replacement
To replace the EMI shield:
1. Insert the shield so the bottom flange engages the frame.
2. Tilt the shield flush against the frame so the springfingers snugly contact
the frame.
3. Install six Phillips screws to secure the shield in place.
SPARCcenter 2000/2000E Service Manual—June 1996
Phillips screws
EMI shield