Sun Microsystems SPARCcenter 2000 Service Manual page 113

11. Remove the springfingers.
Remove three screws securing each of the two sets of springfingers to the
face of the supply. See Figure 7-6. Set these aside for installation on the new
power supply.
Screws (6 places)
AC distribution unit
Figure 7-6
Replace the Power Supply
1. Install the springfingers from the old supply onto the new supply.
2. Install the new supply using Section 7.3.1, "Single Power Supply Cabinet
in a Non Redundant-Capable Chassis" in reverse order.
Major Subassemblies
Removing the Power Supply
J2 and J3
Power supply
Springfingers (2 each
AC Input socket
7
7-7