Sun Microsystems SPARCcenter 2000 Service Manual page 215

3. Hold the card by the edges near the connector and gently rock the card
back and forth to loosen it from the socket.
Caution – The connector housing will break if the SBus card is tilted too far.
!
4. Lift the SBus card from the socket at an angle while guiding the face plate
out from the backpanel opening and under the springfingers.
See Figure 10-5.
5. Place the SBus card in an antistatic bag.
6. If the SBus card is not immediately replaced, install a filler panel on the
backpanel opening of the system board. To secure the filler panel, use the
screws that were removed in step 1.
Caution – Installing the filler panel upside down will create a gap at the top
!
edge of the SBus slot opening and impair system cooling.
Figure 10-5 Removing or Installing an SBus Card
10.4.2 Preparing a New SBus Card
1. Open the protective packaging and take out the SBus card.
System Boards and Component Replacement
SBus card Springfingers
10
10-7