Sun Microsystems SPARCcenter 2000 Service Manual page 164

7
7.13.7 Connecting the Power Cord
7-58
Perform these tasks in order to replace the power cord.
Safety and Tools Requirements
Powering Off the System
Vented Front Panels
Rear Screen Panel
Side Panels
Use instructions below to connect the power cord to the differential SCSI tray:
1. Locate the power cord for the differential SCSI disk tray.
2. Connect the female end of the power cord to the power receptacle at the
rear of the differential SCSI disk tray. See Figure 7-53.
Figure 7-53 Location of the Power Receptacle on the Tray
3. Route the power cord for the tray you are installing down the right side
and along the bottom of the cabinet.
4. Route the cord up through the cutout to the AC distribution unit.
5. Plug the power cord for the tray into the AC distribution unit. See
Figure 7-54.
Warning – The AC distribution unit serves as the primary disconnect device
for the Differential SCSI disk tray. Do not plug the tray into a power source
other than the AC distribution unit. Personal injury may result if you work on
a tray that is plugged into another power source since that power source may
still be active when you work on the tray.
SPARCcenter 2000/2000E Service Manual—June 1996
page 5-1
page 6-1
page 7-3
page 7-4
page 7-5
Power receptacle