Sun Microsystems SPARCcenter 2000 Service Manual page 301

•
•
•
•
Note – If the SPARCcenter 2000 system has more than one
however, the ID numbers for all
numbers for any 8 mm tape drives or 4 mm tape auto-loaders.
Full-height tape drives
Figure E-6
SCSI Targeting
If the tape drive replaces one previously installed in the drive bay, keep the
same SCSI address assigned to the drive that was replaced.
If the tape drive is installed in a previously unused drive bay, assign the
next available SCSI address to the tape drive (from 0 to 6, depending on the
system configuration). For example:
Your system has both a CD-ROM drive and a
bottom right bay, ID6 and ID 5. If all other drive bays are empty, you can:
Install the tape drive in any of the other three drive bays.
Assign the next available SCSI address, ID 4 in this example, to the newly
installed tape drive (regardless of which bay is used).
Three Locations: Full Height 8 mm Tape Drives
1
-inch tape drive in the
/
4
1
-inch tape drives must be higher than the ID
/
4
SCSI ID switch
ID 6 & ID 5,
CD-ROM and
1
/
-inch tape
4
E
1
-inch tape drive,
/
4
E-5