Converting An Airdefense Sensor Back To An Ap; Clearing The Airdefense Sensor Software From The Ap's Configuration - Nortel 2360 Configuration Manual

Converting an AirDefense sensor back to an AP

Once an AP is converted to an AirDefense sensor, you can convert the AP back to a Nortel Access Point by doing the
following:
1
Open a Web browser and establish a secure (https) connection to the converted AP.
2
Click the Revert button in the converted AP's Web interface.
When you do this, the AP reboots and comes up as a Nortel Access Point.

Clearing the AirDefense sensor software from the AP's configuration

To clear the AirDefense sensor software file from the AP's configuration, use the following command:
clear ap ap-num image
For example, the following command causes the AirDefense sensor software file to be cleared from the configuration of
Distributed AP 1:
WSS# clear ap 1 image
success: change accepted.
The next time the AP is booted, it will come up as a Nortel Access Point.
AirDefense integration with the Nortel WLAN 2300 system 341
Nortel WLAN—Security Switch 2300 Series Configuration Guide