Nortel 2360 Configuration Manual page 200

200 Configuring APs
Figure 1. Example Nortel network
serial-id 0322199997
2330
Port
1
WSS1
System IP address
10.10.10.4
Port
3
Wired
authentication
client
VLANs on WSS1
VLAN 2 mgmt, port 5, 10.10.10.4/24
VLAN 4 blue, port 5, tag 20, 10.10.20.2/24
VLAN 3 red, port 5, tag 30
To configure APs, perform the following tasks, in this order:
• Specify the country of operation.
• Configure AP access ports, AP connections, and dual homing.
• If required, configure radio-specific parameters, which include the channel number, transmit power, and
external antenna model.
Note.
these values. You do not need to specify an external antenna model unless a radio
uses an external antenna.
However, if you do install an external antenna, you must ensure that the external
antenna model parameter you specify exactly matches the external antenna that is
attached to the AP's external antenna port, in order to meet regulatory
requirements.
NN47250-500 (320657-F Version 02.01)
serial-id 0322199996
2330
external antenna
model 5303
Port
2
Port
5
Port
4
2330
serial-id 0322199995
You do not need to set channels and power if you use Auto-RF to set
WSS2
serial-id 0322199999
2330
System IP address
10.10.40.4
10.10.40.19/24
10.10.20.19/24
Layer 2
10.10.30.19/24
10.10.60.19/24
10.10.10.19/24
10.10.60.18/24
10.10.50.19/24
WMS
WSS3
System IP address
10.10.50.4
RADIUS
servers
10.10.70.20
Router
10.10.70.40
Layer 2
2330
serial-id 0322199998
Router
Layer 2