Modifying An Existing Security Acl - Nortel 2360 Configuration Manual

Modifying an existing security ACL

You can use the modify editbuffer-index portion of the set security acl command to modify an active security ACL. For
example, suppose the ACL acl-111 currently blocks some packets from IP address 192.168.254.12 with the mask
0.0.0.255 and you want to change the ACL to permit all packets from this address. Follow these steps:
1
To display all committed security ACLs, type the following command:
WSS# show security acl info
ACL information for all
set security acl ip acl-111 (hits #4 0)
----------------------------------------------------
1. deny IP source IP 192.168.254.12 0.0.0.255 destination IP
any
2. permit IP source IP 192.168.253.11 0.0.0.0 destination IP
any
set security acl ip acl-2 (hits #1 0)
----------------------------------------------------
1. permit L4 Protocol 115 source IP 192.168.1.11 0.0.0.0
destination IP 192.168.1.15 0.0.0.0 precedence 0 tos 0
enable-hits
2
To modify the first ACE in acl-111, type the following commands:
WSS# set security acl ip acl-111 permit 192.168.254.12 0.0.0.0 modify 1
WSS# commit security acl acl-111
success: change accepted.
3
To view the results, type the following command:
WSS# show security acl info
ACL information for all
set security acl ip acl-111 (hits #4 0)
----------------------------------------------------
1. permit IP source IP 192.168.254.12 0.0.0.0 destination IP
any
2. permit IP source IP 192.168.253.11 0.0.0.0 destination IP
any
set security acl ip acl-2 (hits #1 0)
----------------------------------------------------
1. permit L4 Protocol 115 source IP 192.168.1.11 0.0.0.0
destination IP 192.168.1.15 0.0.0.0 precedence 0 tos 0
enable-hits
Configuring and managing security ACLs 429
Nortel WLAN—Security Switch 2300 Series Configuration Guide