Deleting A Server Group; Radius And Server Group Configuration Scenario - Nortel 2360 Configuration Manual

Deleting a server group

To remove a server group, type the following command:
clear server group group-name
For example, to delete the server group shorebirds, type the following command:
WSS# clear server group shorebirds
success: change accepted.
The members of the group remain configured, although no server groups are shown:
WSS# show aaa
Default Values
authport=1812 acctport=1813 timeout=5 acct-timeout=5
retrans=3 deadtime=0 key=(null) author-pass=(null)
Radius Servers
Server
-----------------
sandpiper
heron
coot
egret
Server groups

RADIUS and server group configuration scenario

The following example illustrates how to declare four RADIUS servers to a WSS and configure them into two
load-balancing server groups, swampbirds and shorebirds:
1
Configure RADIUS servers. Type the following commands:
WSS# set radius server pelican address 192.168.253.11 key elm
WSS# set radius server seagull address 192.168.243.12 key fir
WSS# set radius server egret address 192.168.243.15 key pine
WSS# set radius server sandpiper address 192.168.253.17 key oak
2
Place two of the RADIUS servers into a server group called swampbirds. Type the following command:
WSS# set server group swampbirds members pelican seagull
3
Enable load balancing for swampbirds. Type the following command:
WSS# set server group swampbirds load-balance enable
4
Place the other RADIUS servers in a server group called shorebirds. Type the following command:
WSS# set server group shorebirds members egret pelican sandpiper
Addr Ports
----------------- -----------------------------------------------------
192.168.253.3 1812 1813
192.168.253.1 1812 1813
192.168.253.4 1812 1813
192.168.253.2 1812 1813
Nortel WLAN—Security Switch 2300 Series Configuration Guide
Configuring communication with RADIUS 571
T/o Tries Dead State
5 3 0 UP
5 3 0 UP
5 3 0 UP
5 3 0 UP