Nortel 2360 Configuration Manual page 316

316 Configuring user encryption
WPA enabled:
ciphers: cipher-tkip, cipher-wep40
authentication: 802.1X
TKIP countermeasures time: 60000ms
...
7
Map service profile wpa-wep to radio profile rp2. Type the following commands:
WSS# set radio-profile rp2 service-profile wpa-wep
success: change accepted.
8
Apply radio profile rp2 to radio 1 on port 5 and to radios 1 and 2 on port 11, enable the radios, and verify
the configuration changes. Type the following commands:
WSS# set ap 5,11 radio 1 radio-profile rp2 mode enable
success: change accepted.
WSS# set ap 11 radio 2 radio-profile rp2 mode enable
success: change accepted.
WSS# show ap config
Port 5: AP model: 2330, POE: enable, bias: high, name: AP05
boot-download-enable: YES
force-image-download: YES
Radio 1: type: 802.11a, mode: enabled, channel: 36
tx pwr: 1, profile: rp2
auto-tune max-power: default
Port 11: AP model: 2330, POE: enable, bias: high, name: AP11
boot-download-enable: YES
force-image-download: YES
Radio 1: type: 802.11g, mode: enabled, channel: 6
tx pwr: 1, profile: rp2
auto-tune max-power: default
Radio 2: type: 802.11a, mode: enabled, channel: 36
tx pwr: 1, profile: rp2
auto-tune max-power: default
9
Save the configuration. Type the following command:
WSS# save config
success: configuration saved.
NN47250-500 (320657-F Version 02.01)