Nortel 2360 Configuration Manual page 223

Table 2: Defaults for service profile parameters (continued)
Parameter
transmit-rates
user-idle-timeout
web-portal-acl
web-portal-form
web-portal-session-
timeout
Radio Behavior When Parameter Set
Default Value
To Default Value
802.11a: Accepts associations only from clients that
support one of the mandatory rates.
• mandatory:
6.0,12.0,24.0 Sends beacons at the specified rate
(6 Mbps for 802.11a, 2 Mbps for 802.11b/
• beacon-rate: 6.0
g).
• multicast-rate:
Sends multicast data at the highest rate
auto
that can reach all clients connected to the
• disabled: none
radio.
802.11b:
Accepts frames from clients at all valid
• mandatory:
data rates. (No rates are disabled by
1.0,2.0
default.)
• beacon-rate: 2.0
• multicast-rate:
auto
• disabled: none
802.11g:
• mandatory:
1.0,2.0,5.5,11.0
• beacon-rate: 2.0
• multicast-rate:
auto
• disabled: none
180 Allows a client to remain idle for 180
seconds (3 minutes) before WSS Software
changes the client's session to the
Disassociated state.
portalacl If set to portalacl and the service profile
fallthru is set to web-portal, radios use the
Note: This is the portalacl ACL to filter traffic for Web
default only if the Portal users during authentication.
fallthru type on the
If the fallthru type is web-portal but
service profile has
web-portal-acl is set to an ACL other
been set to
than portalacl, the other ACL is used.
web-portal.
If the fallthru type is not web-portal,
Otherwise, the value
radios do not use the web-portal-acl
is unconfigured.
setting.
Not configured For Web Portal Web-based AAA users,
serves the default login web page or, if
configured, the SSID-specific login web
page.
5 Allows a Web Portal Web-based AAA
session to remain in the Deassociated state
5 seconds before being terminated
automatically.
Nortel WLAN—Security Switch 2300 Series Configuration Guide
Configuring APs 223