Disabling Enforcement Of Soda Agent Checks - Nortel 2360 Configuration Manual

Disabling enforcement of SODA agent checks

When SODA functionality is enabled for a service profile, by default the SODA agent checks are downloaded to a client
and run before the client is allowed on the network. You can optionally disable the enforcement of the SODA security
checks, so that the client is allowed access to the network immediately after the SODA agent is downloaded, rather than
waiting for the security checks to be run.
To disable (or re-enable) the enforcement of the SODA security checks, use the following command:
set service-profile name enforce-checks {enable | disable}
For example, the following command disables the enforcement of the SODA security checks, allowing network access
to clients after they have downloaded the SODA agent, but without requiring that the SODA agent checks be completed:
WSS# set service-profile sp1 enforce-checks disable
success: change accepted.
Note that if you disable the enforcement of the SODA security checks, you cannot apply the success and failure URLs to
client devices. In addition, you should not configure the SODA agent to refer to the success and failure pages on the
WSS if you have disabled enforcement of SODA agent checks.
Configuring SODA endpoint security for a WSS 601
Nortel WLAN—Security Switch 2300 Series Configuration Guide