Locating An Rfid Tag - Nortel 2360 Configuration Manual

332 Configuring APs to be AeroScout listeners
• Set the channel on each radio to the channel on which the RFID tags transmit. You can use the same channel on all
the RFID tags.
• Map the AP radios to the radio profile and enable the radios.
Note.
An AP always forwards RFID tag information to its WSS, even of RFID mode is
disabled.
The following example shows the commands to configure three Distributed APs to be AeroScout listeners. This example
assumes that the APs have already been installed and configured.
WSS# set service-profile rfid-listeners ssid-type clear
success: change accepted.
WSS# set radio-profile rfid-listeners active-scan disable
success: change accepted.
WSS# set radio-profile rfid-listeners auto-tune channel-config disable
success: change accepted.
WSS# set radio-profile rfid-listeners rfid-mode enable
success: change accepted.
WSS# set radio-profile rfid-listeners service-profile rfid-listeners
success: change accepted.
WSS# set ap 67 radio 1 channel 7
success: change accepted.
WSS# set ap 68 radio 1 channel 7
success: change accepted.
WSS# set ap 69 radio 1 channel 7
success: change accepted.
WSS# set ap 67 radio 1 radio-profile rfid-listeners mode enable
success: change accepted.
WSS# set ap 68 radio 1 radio-profile rfid-listeners mode enable
success: change accepted.
WSS# set ap 69 radio 1 radio-profile rfid-listeners mode enable
success: change accepted.

Locating an RFID tag

You can use an AeroScout Engine or WLAN Management Software to locate an asset to which an RFID tag is attached.
NN47250-500 (320657-F Version 02.01)