Enabling The Spanning Tree Protocol - Nortel 2360 Configuration Manual

368 Configuring and managing spanning tree protocol

Enabling the spanning tree protocol

STP is disabled by default. You can enable STP globally or on individual VLANs.
To enable STP, use the following command:
set spantree {enable | disable}
[{all | vlan vlan-id | port port-list vlan-id}]
To enable STP on all VLANs configured on a WSS, type the following command:
WSS# set spantree enable
success: change accepted.
To verify the STP state and display the STP parameter settings, enter the show spantree command. For infor-
mation, see "Displaying spanning tree information" (page
NN47250-500 (320657-F Version 02.01)
382).