Nortel 2360 Configuration Manual page 292

292 Configuring user encryption
Table 1: Wireless encryption defaults
Encryption Type
RSN
WPA
Dynamic WEP
Static WEP
Figure 1 shows the client support when the default encryption settings are used. A radio using the default
encryption settings encrypts traffic for non-WPA dynamic WEP clients but not for WPA clients or static WEP
clients. The radio disassociates from these other clients.
NN47250-500 (320657-F Version 02.01)
Client Support Default State
RSN clients Disabled
Non-RSN clients
WPA clients Disabled
Non-WPA clients
WEP clients Enabled
(WPA and RSN not
supported)
WEP clients Disabled
(WPA and RSN not
supported)
Configuration Required in WSS
Software
• Enable the RSN information
element (IE).
• Specify the supported cipher
suites (CCMP, TKIP, 40-bit
WEP, 104-bit WEP). TKIP is
enabled by default when the
RSN IE is enabled.
• Enable the WPA information
element (IE).
• Specify the supported cipher
suites (CCMP, TKIP, 40-bit
WEP, 104-bit WEP). TKIP is
enabled by default when the
WPA IE is enabled.
None
• Configure the static key(s).
• Assign keys to multicast and
unicast traffic.