Using an AeroScout engine
1
Load the site map in AeroScout System Manager.
2
Mark the origin point (0,0), if not already done.
3
Calibrate distance, if not already done.
4
Add each AP configured as a listener to the map, and enter its IP address.
Note.
5
Enable RSSI location calculation.
6
Enable tag positioning.
7
Enable the map to use the APs.
To check an AP's status, right-click on the AP icon and select Status.
To look up a AP's IP address, use the show ap status command.
Nortel WLAN—Security Switch 2300 Series Configuration Guide
Configuring APs to be AeroScout listeners 333