Backing Up And Restoring The System - Nortel 2360 Configuration Manual

files do not match, WSS Software does not restart the WSS but instead displays a message advising you to
either save the configuration changes or use the force option.

Backing up and restoring the system

WSS Software has commands that enable you to easily backup and restore
backup system [tftp:/ip-addr/]filename [all | critical]
restore system [tftp:/ip-addr/]filename [all | critical] [force]
The backup command creates an archive in Unix tape archive (tar) format.
The restore command unzips an archive created by the backup command and copies the files from the archive
onto the switch. If a file in the archive has a counterpart on the switch, the archive version of the file replaces
the file on the switch. The restore command does not delete files that do not have counterparts in the archive.
For example, the command does not completely replace the user files area. Instead, files in the archive are
added to the user files area. A file in the user area is replaced only if the archive contains a file with the same
name.
You can create or unzip an archive located on a TFTP server or in the switch's nonvolatile storage. If you
specify a TFTP server as part of the filename with the backup command, the archive is copied directly to the
TFTP server and not stored locally on the switch.
Both commands have options to specify the types of files you want to back up and restore:
• critical—Backs up or restores system files, including the configuration file used when booting, and
certificate files. The size of an archive created by this option is generally 1MB or less. This is the default
for the restore command.
• all—Backs up or restores the same files as the critical option, and all files in the user files area of
nonvolatile storage. (The user files area contains the set of files listed in the file section of dir command
output.) Archive files created by the all option are larger than files created by the critical option. The file
size depends on the files in the user area, and the file can be quite large if the user area contains image
files. This is the default for the backup command.
Note.
Nortel recommends deleting unneeded image files before creating or restoring an
archive.
Use the critical option if you want to back up or restore only the system-critical files required to operate and
communicate with the switch. Use the all option if you also want to back up or restore Web-based AAA pages,
backup configuration files, image files, and any other files stored in the user files area of nonvolatile storage.
The maximum supported file size is 32 MB. If the file size of the tarball is too large, delete unnecessary files
(such as unneeded copies of system image files) and try again, or use the critical option instead of the all
option.
Neither option archives image files or any other files listed in the Boot section of dir command output. The all
option archives image files only if they are present in the user files area.
If the archive's files cannot fit on the switch, the restore operation fails.
Nortel WLAN—Security Switch 2300 Series Configuration Guide
Managing system files 663
WSS
system and user files: