Displaying Blocked Stp Ports - Nortel 2360 Configuration Manual

Displaying blocked STP ports

To display information about ports that are in the STP blocking state, use the following command:
show spantree blockedports [vlan vlan-id]
To display information about blocked ports on a WSS for the default VLAN (VLAN 1), type the following
command:
WSS# show spantree blockedports vlan default
Port
------------------------------------------------------------------------
22
Number of blocked ports (segments) in VLAN 1 : 1
(For information about the fields in the output, see the
Line Reference.)
Vlan Port-State Cost Prio Portfast
190 Blocking
Nortel WLAN—Security Switch 2300 Series Configuration Guide
Configuring and managing spanning tree protocol 385
4 128 Disabled
Nortel WLAN Security Switch 2300 Series Command