Nortel 2360 Configuration Manual page 90

90 Configuring and managing ports and VLANs
applies default settings appropriate for the port type.
example, the AP column lists default settings that WSS Software applies when you change a port type to ap (access
point).
Table 1: Port Defaults set by port type change
Port type
Parameter
AP Access
VLAN Removed from all
membership VLANs. You cannot
assign an AP access
port to a VLAN. WSS
Software automatically
assigns AP access ports
to VLANs based on
user traffic.
Spanning Tree Not applicable
Protocol (STP)
802.1X Uses authentication
parameters configured
for users.
Port groups Not applicable
IGMP snooping Enabled as users are
authenticated and join
VLANs.
Maximum user Not applicable
sessions
Table 2 lists how many APs you can configure on a WSS, and how many APs a switch can boot. The numbers are for
directly connected and Distributed APs combined.
Table 2: Maximum APs supported per switch
WSS Model
2382
2380
2360/2361
2350
NN47250-500 (320657-F Version 02.01)
Table 1 lists the default settings applied for each port type. For
Wired Authentication
Removed from all VLANs. You
cannot assign a wired
authentication port to a VLAN.
WSS Software automatically
assigns wired authentication
ports to VLANs based on user
traffic.
Not applicable
Uses authentication parameters
configured for users.
Not applicable
Enabled as users are
authenticated and join VLANs.
1 (one)
Maximum That Can Be
Configured
320
300
30
8
Network
None
Note: If you clear a port,
WSS Software resets the port
as a network port but does
not add the port back to any
VLANs. You must explicitly
add the port to the desired
VLAN(s).
Based on the STP states of
the VLANs the port is in.
No authentication.
None
Enabled as the port is added
to VLANs.
Not applicable
Maximum That Can Be
Booted
32, 64, 96 or 128,
depending on the license
level
40, 80, or 120, depending
on the license level
12
3