Nortel 2360 Configuration Manual page 149

WSS# set ip route default 10.20.10.1 1
success: change accepted.
WSS # show ip route
Router table for IPv4
Destination/
Mask
0.0.0.0/ 0
10.10.10.10/24
10.10.10.10/32
10.20.10.10/24
10.20.10.10/32
224.0.0.0/ 4
4
Configure the DNS domain name and DNS server entries, enable the DNS service, and verify the
configuration changes. Type the following commands:
WSS# set ip dns domain example.com
success: change accepted.
WSS# set ip dns server 10.10.10.69 PRIMARY
success: change accepted.
WSS# set ip dns server 10.20.10.69 SECONDARY
success: change accepted.
WSS# set ip dns enable
success: change accepted.
WSS# show ip dns
Domain Name: example.com
DNS Status: enabled
IP Address
-----------------------------------
10.10.10.69
10.20.10.69
5
Configure time zone, summertime, and NTP parameters and verify the configuration changes. Type the
following commands:
WSS# set timezone PST -8
success: change accepted.
WSS# show timezone
Timezone is set to 'PST', offset from UTC is -8:0 hours.
WSS# set summertime PDT
success: change accepted.
Configuring and managing IP interfaces and services 149
Proto Metric
Static 1 Router
IP 0 Direct
IP 0 Local
IP 0 Direct
IP 0 Local
IP 0 Local
Type
PRIMARY
SECONDARY
Nortel WLAN—Security Switch 2300 Series Configuration Guide
NH-Type VLAN:Interface
Gateway
10.20.10.17
vlan:1:ip
vlan:1:ip:10.10.10.10/24
vlan:1:ip
vlan:1:ip:10.20.10.10/24
MULTICAST