Nortel 2360 Configuration Manual page 233

Table 7: Configurable profile parameters for distributed APs (continued)
Parameter
radio num auto-tune max-power
radio num mode
radio num radio-profile
radiotype
APs that receive their configurations from the Auto-AP profile also receive the radio settings from the radio
profile used by the Auto-AP profile. Likewise, the SSIDs and encryption settings come from the service
profiles mapped to the radio profile. To use a radio profile other than default, you must specify the radio
profile you want to use. (See
Changing AP parameter values
The commands for configuring AP and radio parameters for the Auto-AP profile are the same as the
commands for configuring an individual Distributed AP. Instead of specifying a Distributed AP number with
the command, specify auto. For more information about the syntax, see the "AP Commands" chapter of the
Nortel WLAN Security Switch 2300 Series Command Line Reference.
AP Parameters:
set ap auto bias {high | low}
set ap auto blink {enable | disable}
set ap auto force-image-download {enable | disable}
set ap auto group name
set ap auto mode {enable | disable}
set ap auto persistent [ap-num | all]
set ap auto upgrade-firmware {enable | disable}
Radio Parameters:
set ap auto radiotype {11a | 11b| 11g}
set ap auto radio {1 | 2} auto-tune max-power power-level
set ap auto radio {1 | 2} mode {enable | disable}
set ap auto radio {1 | 2} radio-profile name mode {enable | disable}
Default Value
default
enabled
default
11g
(or 11b for country codes where
802.11g is not allowed)
"Specifying the radio profile used by the auto-AP profile" (page
Nortel WLAN—Security Switch 2300 Series Configuration Guide
Configuring APs 233
234).)