Nortel 2360 Configuration Manual page 319

12 Map service profile wpa-wep-for-mac to radio profile rp3. Type the following commands:
WSS# set radio-profile rp3 service-profile wpa-wep-for-mac
success: change accepted.
13 Apply radio profile rp3 to radio 1 on port 4 and to radios 1 and 2 on port 6 and enable the radios, and
verify the configuration changes. Type the following commands:
WSS# set ap 4,6 radio 1 radio-profile rp3 mode enable
success: change accepted.
WSS# set ap 6 radio 2 radio-profile rp3 mode enable
success: change accepted.
WSS# show ap config
Port 4: AP model: 2330, POE: enable, bias: high, name: AP04
boot-download-enable: YES
force-image-download: YES
Radio 1: type: 802.11a, mode: enabled, channel: 36
tx pwr: 1, profile: rp3
auto-tune max-power: default
Port 6: AP model: 2330, POE: enable, bias: high, name: AP06
boot-download-enable: YES
force-image-download: YES
Radio 1: type: 802.11g, mode: enabled, channel: 6
tx pwr: 1, profile: rp3
auto-tune max-power: default
Radio 2: type: 802.11a, mode: enabled, channel: 36
tx pwr: 1, profile: rp3
auto-tune max-power: default
14 Save the configuration. Type the following command:
WSS# save config
success: configuration saved.
Nortel WLAN—Security Switch 2300 Series Configuration Guide
Configuring user encryption 319