Nortel 2360 Configuration Manual page 65

The IP addresses, usernames, and passwords in this document are examples. Use values that are appropriate for your
organization.
If you configure time and date parameters, you will be required to enter a name for the timezone, and then enter the value
of the timezone (the offset from UTC) separately. You can use a string of up to 32 alphabetic characters as the timezone
name.
Figure 2 shows an example. Users bob and alice can access encrypted SSID corporate on either of the APs. Users user1
and user2 can use the same APs to access unencrypted SSID public. Although the same hardware supports both SSIDs
and sets of users, AAA ensures that only the users who are authorized to access an SSID can access that SSID. Users of
separate SSIDs can even be in the same VLAN, as they are in this example.
Figure 2. Single-switch deployment
Console
Port
2
alice
user1
2350-aabbcc# quickstart
This will erase any existing config. Continue? [n]: y
Answer the following questions. Enter '?' for help. ^C to break
out
System Name [2350]: 2350-mrktg
Country Code [US]: US
System IP address []: 172.16.0.21
System IP address netmask []: 255.255.255.0
Default route []: 172.16.0.20
Do you need to use 802.1Q tagged default VLAN [Y/N]? Y: y
Specify the port number that needs to be tagged [1-2, <CR> ends
config]: 2
Specify the tagged value for port [2] [<CR> ends config:] 100
Specify the port number that needs to be tagged [1-2, <CR> ends
config]:
Admin username [admin]: wssadmin
Admin password [optional]: letmein
2350-Corp
10.10.10.4
Port
3
user2
Nortel WLAN—Security Switch 2300 Series Configuration Guide
Backbone
Corporate resources
bob
WSS setup methods 65
Internet