Changing The Bridge Priority - Nortel 2360 Configuration Manual

Changing the bridge priority

To change the bridge priority, use the following command:
set spantree priority value {all | vlan vlan-id}
Specify a bridge priority from 0 through 65,535. The default is 32,768. The all option applies the change
globally to all VLANs. Alternatively, specify an individual VLAN.
To change the bridge priority of VLAN pink to 69, type the following command:
WSS# set spantree priority 69 vlan pink
success: change accepted.
Configuring and managing spanning tree protocol 371
Nortel WLAN—Security Switch 2300 Series Configuration Guide