Nortel 2360 Configuration Manual page 698

698 Appendix A:Supported RADIUS attributes
Attribute Type
User-Name 1
User-Password 2
CHAP- 3
Password
NAS-IP- 4
Address
Service-Type 5
Filter-Id 11
NN47250-500 (320657-F Version 02.01)
Table 1: 802.1X attributes
Rcv in Sent in Sent in
Access Access Acct
Resp? Reqst? Reqst?
No Yes Yes
No Yes No
No Yes No
No Yes Yes
No Yes Yes
Yes No Optional
Description and Values
String. Name of the user to be
authenticated. Used only in Request
packets.
Password of the user to be authenticated,
unless a CHAP-Password is used.
Password of the user to be authenticated,
unless a User-Password is used.
IP address sent by the WSS.
Access type, which can be one of the
following:
• 2—Framed; for network user access
• 6—Administrative; for
administrative access to the WSS,
with authorization to access the
enabled (configuration) mode. The
user must enter the enable command
and the correct enable password to
access the enabled mode.
• 7—NAS-Prompt; for administrative
access to the nonenabled mode only.
In this mode, the user can still enter
the enable command and the correct
enable password to access the
enabled mode.
For administrative sessions, the WSS
always sends 6 (Administrative).
The RADIUS server can reply with one
of the values listed above.
If the service-type is not set on the
RADIUS server, administrative users
receive NAS-Prompt access, and network
users receive Framed access.
Note: WSS Software will quietly accept
Callback Framed but you cannot select
this access type in WSS Software.
Name of an access control list (ACL) to
filter outbound or inbound traffic. Use the
form ACL name.in and ACL name.out.
(For details, see "Configuring and
managing security ACLs" (page 407).)