Displaying Multicast Receivers - Nortel 2360 Configuration Manual

Displaying multicast receivers

To display information about the multicast receivers only without also displaying all the other multicast information, use
the following command:
show igmp receiver-table [vlan vlan-id]
[group group-ip-addr/mask-length]
Use the group parameter to display receivers for a specific group or set of groups. For example, to display receivers for
multicast groups 237.255.255.1 through 237.255.255.255, in all VLANs, type the following command:
WSS# show igmp receiver-table group 237.255.255.0/24
VLAN: red
Session
---------------
237.255.255.2
237.255.255.119
VLAN: green
Session
---------------
237.255.255.17
237.255.255.255
(For information about the fields in the output, see the
Reference.)
Port Receiver-IP
------- ---------------
2 10.10.20.19
3 10.10.30.31
Port Receiver-IP
------- ---------------
11 10.10.40.41
6 10.10.60.61
Nortel WLAN Security Switch 2300 Series Command Line
Nortel WLAN—Security Switch 2300 Series Configuration Guide
Configuring and managing IGMP snooping 405
Receiver-MAC
------------------------
00:02:04:06:09:0d
00:02:04:06:01:0b
Receiver-MAC
------------------------
00:02:06:08:02:0c
00:05:09:0c:0a:01
TTL
--------
112
112
TTL
--------
12
111