Nortel 2360 Configuration Manual page 54

54 Using the command-line interface
You can fully operate the WLE2340 only if the following commands are set:
To set static ip address for AP at WSS:
#set ap <ap_number> boot-configuration switch mode enable
#set ap <ap_number> boot-configuration switch switch <switch IP address>
#set ap <ap_number> boot-configuration ip <ap_static_ip_address> netmask <netmask>
gateway <gateway IP address> mode enable
To set snoop mapping (recommend snap-length is 100):
#set snoop <snoop name> observer <WLE-2340_ip_address> snap-length <snap-length>
#set snoop map <snoop name> ap <ap_number> radio <1 or 2>
#set snoop <snoop name> mode enable
Once you finish the above setup, the WLE2340 will detect location APs.
To check snoop settings:
#show snoop stats
#show snoop info
NN47250-500 (320657-F Version 02.01)