Copying And Modifying The Web Login Page; Custom Login Page Scenario - Nortel 2360 Configuration Manual

506 Configuring AAA for network users
• If the switch's nonvolatile storage has a page in web named wba_form.html (web/wba_form.html), WSS
Software serves this page. This applies to all wired authentication users. The wba_form.html page also is
served to SSID users if the SSID's service profile does not specify a custom page.
• If there is no wba_form.html page and no custom page in the service profile (for an SSID), WSS Software
serves the default page.

Copying and modifying the Web login page

To copy and modify the Nortel Web login page:
1
Configure an unencrypted SSID on a WSS. The SSID is temporary and does not need to be one
you intend to use in your network. To configure the SSID, use the following commands:
set service-profile name ssid-name ssid-name
set service-profile name ssid-type clear
set service-profile name auth-fallthru web-portal
set radio-profile name service-profile name
set {ap port-list | ap ap-num} radio {1 | 2}
radio-profile name mode enable
Use the first two commands to configure a temporary SSID and temporary radio profile. Use
the last command to map the temporary radio profile with the disabled radio, and enable the
radio.
Note.
disable the radio profile the radio is in and remove the radio from the profile.
2
From your PC, attempt to directly access the temporary SSID. The WSS should serve the login
page.
3
Use your browser to save a copy of the page.
4
Use a Web page editor or text editor to modify the page title, greeting, logo, and warning text.
5
Save the modified page.
Note.
Filenames and paths for image source files must be relative to the HTML page.
For example, if login page mycorp-login.html and image file mylogo.gif are located in
subdirectory mycorp/, specify the image source as mylogo.gif, not mycorp/mylogo.gif. (See
the following example.)

Custom login page scenario

1
Do the following on the WSS:
NN47250-500 (320657-F Version 02.01)
If the radio you plan to use is already in service, first you will need to