Nortel 2360 Configuration Manual page 324

324 Configuring Auto-RF
Parameter
Radio profile parameters
channel-config
channel-interval
channel-holddown
channel-lockdown
power-config
power-interval
power-lockdown
power-ramp-interval
Individual radio parameters
max-power
NN47250-500 (320657-F Version 02.01)
Table 1: Defaults for Auto-RF parameters
Default Value
enable
3600
900
disabled
disable
300
disabled
60
Maximum
allowed for
country of
operation
Radio Behavior When Parameter
Set To Default Value
When the radio is first enabled,
Auto-RF sets the channel based on the
channels in use on neighboring access
points.
Every 3600 seconds, WSS Software
examines the RF information gathered
from the network and determines
whether the channel needs to be
changed to compensate for RF changes.
WSS Software maintains the channel
setting on a radio for at least 900
seconds regardless of RF changes.
WSS Software continues to
dynamically change channels if needed
based on network conditions.
WSS Software uses the highest power
level allowed for the country of
operation or the highest supported by
the hardware, whichever is lower.
Every 300 seconds, WSS Software
examines the RF information gathered
from the network and determines
whether the power needs to be changed
to compensate for RF changes.
WSS Software continues to
dynamically change power settings if
needed based on network conditions.
When Auto-RF determines that power
should be increased or decreased, WSS
Software changes the power by 1 dBm
every 60 seconds until the power setting
is reached.
Auto-RF never sets a radio's power to a
level that is higher than the maximum
allowed for the country of operation
(countrycode).