Setting The System Ip Address As The Source Address - Nortel 2360 Configuration Manual

Setting the system IP address as the source address

By default, RADIUS packets leaving the WSS have the source IP address of the outbound interface on the switch. This
source address can change when routing conditions change. If you have set a system IP address for the WSS, you can use
it as a permanent source address for the RADIUS packets sent by the switch.
To set the WSS system IP address as the address of the RADIUS client, type the following command:
WSS# set radius client system-ip
success: change accepted.
To remove the WSS's system IP address from use as the source address in RADIUS client requests from the switch to its
RADIUS server(s), type the following command:
WSS# clear radius client system-ip
success: change accepted.
The command causes the WSS to select a source interface address based on information in its routing table as the
RADIUS client address.
Configuring communication with RADIUS 565
Nortel WLAN—Security Switch 2300 Series Configuration Guide