Nortel 2360 Configuration Manual page 221

Table 2: Defaults for service profile parameters (continued)
Parameter
beacon
cac-mode
cac-session
cipher-ccmp
cipher-tkip
cipher-wep104
cipher-wep40
cos
dhcp-restrict
idle-client-probing
keep-initial-vlan
long-retry-count
Radio Behavior When Parameter Set
Default Value
To Default Value
enable Sends beacons to advertise the SSID
managed by the service profile.
none Does not limit the number of active user
sessions based on Call Admission Control
(CAC).
14 If session-based CAC is enabled
(cac-mode is set to session), limits the
number of active user sessions on a radio
to 14.
disable Does not use Counter with Cipher Block
Chaining Message Authentication Code
Protocol (CCMP) to encrypt traffic sent to
WPA clients.
enable When the WPA IE is enabled, uses
Temporal Key Integrity Protocol (TKIP)
to encrypt traffic sent to WPA clients.
disable Does not use Wired Equivalent Privacy
(WEP) with 104-bit keys to encrypt traffic
sent to WPA clients.
disable Does not use WEP with 40-bit keys to
encrypt traffic sent to WPA clients.
0 If static CoS is enabled (static-cos is set to
enable), assigns CoS 0 to all data traffic to
or from clients.
disable Does not restrict a client's traffic to only
DHCP traffic while the client is being
authenticated and authorized.
enable Sends a keepalive packet (a null-data
frame) to each client every 10 seconds.
disable Reassigns the user to a VLAN after
roaming, instead of leaving the roamed
user on the VLAN assigned by the switch
where the user logged on.
Note: Enabling this option does not retain
the user's initial VLAN assignment in all
cases.
5 Sends a long unicast frame up to five
times without acknowledgment.
Nortel WLAN—Security Switch 2300 Series Configuration Guide
Configuring APs 221