678 Appendix A:Troubleshooting a WSS
Mark messages are disabled by default. When they are enabled, WSS Software generates a message at the
notice level once every 300 seconds by default.
To enable mark messages, use the following command:
WSS# set log mark enable
success: change accepted.
Saving trace messages in a file
To save the accumulated trace data for enabled traces to a file in the WSS's nonvolatile storage, use the
following command:
save trace filename
To save trace data into the file trace1 in the subdirectory traces, type the following command:
WSS# save trace traces/trace1
Displaying the log configuration
To display your current log configuration, type the following command:
WSS# show log config
Logging console:
Logging console severity:
Logging sessions:
Logging sessions severity:
Logging buffer:
Logging buffer severity:
Logging trace:
Logging trace severity:
Logging buffer size:
Log marking:
Log marking severity:
Log marking interval:
Logging server:
Current session:
Current session severity:
NN47250-500 (320657-F Version 02.01)
enabled
INFO
enabled
INFO
enabled
ERROR
enabled
DEBUG
1048576 bytes
disabled
NOTICE
300 seconds
172.21.12.19 port 514 severity EMERGENCY
disabled
INFO