Clearing Security Acls From The Edit Buffer - Nortel 2360 Configuration Manual

430 Configuring and managing security ACLs

Clearing security ACLs from the edit buffer

Use the rollback command to clear changes made to the security ACL edit buffer since it was last committed.
The ACL is rolled back to its state at the last commit command. For example, suppose you want to remove an
ACE that you just created in the edit buffer for acl-111:
1
To display the contents of all committed security ACLs, type the following command:
WSS# show security acl info
ACL information for all
set security acl ip acl-111 (hits #4 0)
----------------------------------------------------
1. permit IP source IP 192.168.254.12 0.0.0.0
destination IP any
2. permit IP source IP 192.168.253.11 0.0.0.0
destination IP any
set security acl ip acl-2 (hits #1 0)
----------------------------------------------------
1. permit L4 Protocol 115 source IP 192.168.1.11 0.0.0.0
destination IP 192.168.1.15 0.0.0.0 precedence 0 tos 0
enable-hits
2
To view a summary of the security ACLs for which you just created ACEs in the edit buffer,
type the following command:
WSS# show security acl editbuffer
ACL edit-buffer table
ACL
------------------------------- ---- --------------
acl-a
acl-111
3
To view details about these uncommitted ACLs, type the following command.
WSS# show security acl info all editbuffer
ACL edit-buffer information for all
set security acl ip acl-111 (ACEs 3, add 3, del 0,
modified 2)
----------------------------------------------------
1. permit IP source IP 192.168.254.12 0.0.0.0
destination IP any
2. permit IP source IP 192.168.253.11 0.0.0.0
destination IP any
3. deny SRC source IP 192.168.253.1 0.0.0.255
set security acl ip acl-a (ACEs 1, add 1, del 0, modified
0)
----------------------------------------------------
NN47250-500 (320657-F Version 02.01)
Type Status
IP Not committed
IP Not committed