Removing A Subdirectory; Managing Configuration Files; Displaying The Running Configuration - Nortel 2360 Configuration Manual

Boot0: Total: 8928 Kbytes used, 3312 Kbytes free
Boot1: Total: 8197 Kbytes used, 4060 Kbytes free
===============================================================================
temporary files:
Filename
Total: 0 bytes used, 93537 Kbytes free

Removing a subdirectory

To remove a subdirectory from nonvolatile storage, use the following command:
rmdir [subdirname]
To remove subdirectory corp2, type the following example:
WSS# rmdir corp2
success: change accepted.

Managing configuration files

A configuration file contains CLI commands that set up the WSS. The switch loads a designated configuration file
immediately after loading the system software when the software is rebooted. You also can load a configuration file
while the switch is running to change the switch's configuration.
When you enter CLI commands to make configuration changes, these changes are immediately added to the device's
running configuration but are not saved to the configuration file.
This section describes how to display the running configuration and the configuration file, and how to save and load
configuration changes. A procedure is also provided for resetting the WSS to its factory default configuration.

Displaying the running configuration

To display the configuration running on the WSS, use the following command:
show config [area area] [all]
The area area parameter limits the display to a specific configuration area. (For more information, see the
Security Switch 2300 Series Command Line
The all parameter includes all commands that are set at their default values. Without the all parameter, the show config
command lists only those configuration commands that set a parameter to a value other than the default.
To display the running configuration, type the following command:
WSS# show config
# Configuration nvgen'd at 2004-5-10 19:08:38
# Image 2.1.0
# Model WSS
# Last change occurred at 2004-5-10 16:31:14
set trace authentication level 10
set ip dns server 10.10.10.69 PRIMARY
Size Created
Reference.)
Nortel WLAN—Security Switch 2300 Series Configuration Guide
Managing system files 659
Nortel WLAN