Displaying Rf Detection Information - Nortel 2360 Configuration Manual

Displaying RF detection information

You can use the CLI commands listed in
Command
show rfdetect clients
[mac mac-addr]
show rfdetect counters
show rfdetect mobility-domain
[ssid ssid-name | bssid mac-addr]
show rfdetect data
show rfdetect visible mac-addr
show rfdetect visible
ap ap-num [radio {1 | 2}]
show rfdetect visible
ap ap-num [radio {1 | 2}]
show rfdetect countermeasures
show rfdetect vendor-list
show rfdetect ssid-list
show rfdetect black-list
Table 3 to display rogue detection information.
Table 3.Rogue detection show commands
Nortel WLAN—Security Switch 2300 Series Configuration Guide
Rogue detection and counter measures 643
Description
Displays all wireless clients detected on the air.
Displays statistics for rogue and Intrusion
Detection System (IDS) activity detected by the
APs managed by a WSS.
Displays information about rogues detected in a
Mobility Domain.
This command is valid only on the Mobility
Domain's seed switch.
Displays information about all BSSIDs detected
on the air, and labels those that are from rogues
or interfering devices.
This command is valid on any switch in the
Mobility Domain.
Displays the BSSIDs detected by a specific
Nortel radio.
Displays the current status of countermeasures
against rogues in the Mobility Domain.
This command is valid only on the Mobility
Domain seed.
Displays the list of OUIs that are allowed on the
network. An OUI identifies a piece of
networking equipment's vendor. (See
"Configuring a permitted vendor list"
(page 631).)
Displays the list of SSIDs that are allowed on
the network. (See "Configuring a permitted
SSID list" (page 632).)
Displays the list of wireless clients that are not
allowed on the network. (See
client black list" (page 633).)
"Configuring a