Xerox Phaser 3610 Service Manual page 507

Replacement
1. Installing the Feeder Assembly. (Figure 3)
a. position the Feeder Assembly under the actuator
b. Make sure the spring is seated correctly in the chassis cavity.
2. Insert the Nudger Bearing to secure the Feeder Assembly to the transport.
3. Replace the shaft with the Feed Gear on it, and then the One Way Clutch.
4. Position the notch on the Feed Clutch onto the tab on the frame, and secure the clutch onto the
shaft using the e-ring.
5. Check the assembly for the correct spring tension.
6. Replace in reverse order.
Figure 3
Phaser 3610, WorkCentre 3615 Service Manual
Service Parts Disassembly
4-45