Xerox Phaser 3610 Service Manual page 327

Step
• Execute the Diag Digital Output [071-
006] to check the operation of the REGI.
5
CLUTCH.
• Is the REGI. CLUTCH operating normally?
• Execute the Diag Digital Output [071-
001] to check the rotation of the MAIN
6
DRIVE ASSEMBLY.
• Is it working properly?
FIP 1. 284
077-106 Exit On Jam
077-108 Exit Off early Jam
077-109 Exit Off Jam
Cause:
077-106:
Either of the following error codes is displayed in the UI.
050-130 - 050-132 - 050-142
The Exit Sensor does not turn ON within the specified time after the Regi Clutch turned
On.
077-108:
050-130 is displayed in the UI.
After the Exit Sensor turned ON, the Exit Sensor turned OFF before the specified time.
077-109:
050-130 is displayed in the UI.
After the Regi. Sensor turned OFF, the Exit Sensor did not turn OFF within the specified
time.
Solution:
1. Paper jam has occurred. Remove the jammed paper.
2. If there is no jammed paper, or the error still occurs after having removed the jammed paper,
turn the power Off and On to check that the error recurs, then proceed to the FIP.
Check and Action Yes
Go to Step 6.
Replace
(REP 5.6 MCU
Phaser 3610, WorkCentre 3615 Service Manual 2-269
Troubleshooting
No
Go to
FIP 2.10
Go to
PWB)
FIP 2.15