Xerox Phaser 3610 Service Manual page 232

Troubleshooting
Step
Check the connection between the MCU PWB and
the ESS PWB.
1
• Is the ESS HARNESS ASSEMBLY connected
securely?
• Replace the ESS HARNESS ASSEMBLY.
2
• Does an error occur?
• Replace
3
• Does an error occur?
FIP 1. 112
024-910 Tray 1 Paper Size Mismatch
Cause:
The size of paper in the Tray 1does not match the specified print size.
Solution:
1. Open/close Tray, or reseat paper on the manual feed tray.
2. Use the paper that meets the specifications.
3. Make sure that you are using the correct printer driver.
4. Check the Paper Size and Paper Type of the Tray Setting menu on the printer operator panel
and the printer driver.
5. If the problem cannot be solved, replace the corresponding paper feed rolls.
• TRAY 1 FEED ROLL / NUDGER ROLL
• TRAY 1 RETARD ROLL
• RUBBER ROLL ASSEMBLY
• REGI PINCHROLL ASSEMBLY
• REGI PINCH ROLL
2-174 Phaser 3610, WorkCentre 3615 Service Manual
Check and Action
(REP 5.6 MCU PWB).
(PL 7.3 Tray 1/Optional Tray 550-Sheet Feeder
(PL 2.2 Transport
(PL 2.2 Transport
(PL 2.2 Transport
Yes
Go to Step 2.
Go to Step 3.
Replace
(REP 5.1 ESS
PWB)
(PL 2.3 Feed Assembly)
Assembly)
Assembly)
Assembly)
No
Securely connect
the ESS HARNESS
ASSEMBLY
Troubleshooting
complete.
Troubleshooting
complete.
(3/4))