FIP 2.18
Abnormal Noise: When power is turned on
Cause:
Parts to be considered:
•
TONER CARTRIDGE
•
DISPENSE MOTOR
•
MAIN DRIVE ASSEMBLY
•
DRUM CARTRIDGE
•
FUSING ASSEMBLY
•
DRIVE EXIT OUT HOLDER ASSEMBLY
•
DRIVE EXIT IN HOLDER ASSEMBLY
Solution:
Step
•
Execute the Diag Digital Output[093-001]
to check the rotation of the DISPENSE
MOTOR.
•
Is there any abnormal noise from the
1
device? Stop the motor operation within
three seconds. If the motor operation is
continued for three seconds or longer, the
device will be damaged.
•
Reinstall the TONER CARTRIDGE.
•
Turn the power Off and On.
2
•
Does an abnormal noise occur?
•
Execute the Diag Digital Output [071-001]
to check the rotation of the MAIN DRIVE
ASSEMBLY.
•
Is there any abnormal noise from the
3
device? Stop the motor operation within
three seconds. If the motor operation is
continued for three seconds or longer, the
device will be damaged.
•
Replace the DRUM CARTRIDGE.
4
Turn the power Off and On.Does an
•
abnormal noise occur?
(PL 3.1
Xerographics)
(PL 3.3 Toner
Dispense)
(PL 4.1
Drive)
(PL 3.1
Xerographics)
(PL 3.5 Fusing
Assembly)
(PL 4.1
Check and Action
(PL 4.1
Drive)
Drive)
Yes
Go to Step 2.
Replace the
TONER
CARTRIDGE
Go to Step 4.
Go to Step 5.
Phaser 3610, WorkCentre 3615 Service Manual 2-331
Troubleshooting
No
Go to Step 3.
Troubleshooting
complete.
Troubleshooting
complete.
Troubleshooting
complete.