Xerox Phaser 3610 Service Manual page 320

Troubleshooting
FIP 1. 277
072-101 IOT Path 2 SNS On Jam
073-101 IOT Path 3 SNS On Jam
Cause:
072-101:
050-136 is displayed in the UI.
The Tray 2 Path Sensor did not turn ON within the specified time after the Tray 3 Path Sen-
sor turned ON.
073-101:
050-135 is displayed in the UI.
The Tray 3 Path Sensor did not turn ON within the specified time after the Tray 4 Path Sen-
sor turned ON.
Solution:
1. Paper jam has occurred. Remove the jammed paper.
2. If there is no jammed paper, or the error still occurs after having removed the jammed paper,
turn the power Off and On to check that the error recurs, then proceed to the FIP.
Step
Is there any foreign substances or bits of paper
1
found on the paper transport path?
Are the paper feed rolls installed properly?
2
Are the paper feed rolls deformed or worn out?
3
• Execute the Diag Digital Input Tray 2: 071-
119 / Tray 3:071-120 / Tray 4:071-121 to
4
check the operation of the Path Sensor.
• Is the Path Sensor operating normally?
• Execute the Diag Digital Output Tray 2:
071-018 / Tray 3:071-019 / Tray 4:071-020
to check the operation of the OPTIONAL
5
FEEDER CLUTCH ASSEMBLY.
• Is the OPTIONAL FEEDER CLUTCH
ASSEMBLY operating normally?
2-262 Phaser 3610, WorkCentre 3615 Service Manual
Check and Action Yes
Remove the for-
eign substances
and bits of paper,
etc.
Reinstall the cor-
Go to Step 3. responding paper
Replace the cor-
responding paper
feed rolls
Go to Step 5.
Go to Step 6.
No
Go to Step 2.
feed rolls
Go to Step 4.
Go to
FIP 2.07
Go to
FIP 2.13